|
收费岛模具基本知识:模具规格一般为长度4米的,采用3部分主体结构,所以该模具是一种组合形式
的,这样能够整体现浇的方便性;使用钢板厚度为面板4毫米,筋板5毫米,这样在重复使用的时候不
会发生变形的现象。收费岛的钢模板数量应该进行合理的规划,对于施工的图纸要进行研究,确认让
钢模具的配置数量更加合理,制作出来的钢模板是稳固的,这种钢模板采用的厚度都是在四毫米以上
,这种比普通模具都要厚的面板要使用在大型的模具上面,这样整个施工的过程才会,而且钢模板不
会出现变形。
Charge island mold basic knowledge: The mold specification is generally 4 meters in
length, uses 3 part main body structure, therefore this mold is one kind of combination
form, thus can the integral cast-in-place convenience; uses the steel plate thickness is
the panel 4 millimeters, the stiffener plate is 5 mm, so that it will not deform when
reused. The number of steel formwork on the toll island should be reasonably planned, the
construction drawings should be studied to ensure that the number of steel formwork is
more reasonable and the steel formwork produced is stable, the steel formwork used in the
thickness of more than four millimeters, this than ordinary die is thicker than the face
plate to be used in the large mold, so that the entire construction process will, and the
steel template will not appear deformation.
|
|